Wilton 7020/7040 Instruction Manual download pdf (Page 28)

14. Saw must be stopped and electrical supply disconnected before reaching into cutting area.

15. Avoid contact with coolant, especially guarding your eyes.

16. Wait for the blade to finish the cut. The motor will stop and the coolant will stop flowing.

17. Drain coolant back into the saw, from hollow pieces.

18. Wipe up all coolant spills.

19. When completing cuts: all chips and scrap must be removed, excess coolant should be wiped from

the machine, and if necessary mop spilled coolant on the floor.

Operating Instructions Controls

Setting Blade Speed

1. The blade speed is controlled by an adjustment mechanism on the right end of the saw. Speed

increases when the adjustment knob is turned counterclockwise. Speed decreases when the knob is

turned clockwise.

2. A placard on the drive belt guard provides recommended speeds for various materials.

3. A speed indicator is provided on the barrel of the adjustment mechanism. The indicator provides

speed indications in feet per minute and meters per minute. (The meters per minute values are shown

in parenthesis on the indicator.)

4. The feed rates on the placard are expressed in meters per minute. The feed rate graduations available

on the indicator may not match the recommended feed rate. An approximate speed may therefore be

required. For example, to set a speed rate of 25 meters per minute, the indicator would be set about

midway between 21 meters per-minute and the 30 meters-per-minute graduations.

WARNING: TO CHANGE SPEED, THE SAW MOTOR MUST BE OPERATING.

5. Turn the speed adjustment knob to the desired rate setting as determined by the material being cut.

Speed and feed adjustments are sometime better left to the more experienced.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

No comments

Wilton 7020/7040 Instruction Manual Page 28